[mcnelson]

之前有講過架Coolpix5700專整死
LEXAR compactflash card
之前已經?架機去Nikon代理整過3次
每次都係一整死張CF就?去.
點知7月4日保養期滿而家又整死LEXAR 張CF
都唔知香港Nikon代理D人點樣整機
次次都話換底板但係一次又一次發生同一問題
同一問題一年整幾次都整唔掂
真係以後買Nikon機水貨好過.
總之Nikon香港代理 不知所為.

http://www.dchome.net/viewtopic.php?t=19265

http://www.dchome.net/viewtopic.php?t=20327

[KWLBrian]

L記既CF card唔夾你部5700, 你就換別一個牌子既CFcard la
做人咪死牛一面頸

[KWLBrian]

L記既CF card唔夾你部5700, 你就換另一個牌子既CFcard la
做人咪死牛一面頸

[老叟]

講服務水準就冇以前石利洛洋行咁好,個陣時D接待姐姐好靚,行家去仲有九拆添架!!

[Ekamz]

Nikon 機一定要用 scandisk 既 咭ga,
你買一張試下 la, 總好過成日拎去整

[HWC]

Some DC shop said that Lexar CF card is designed for Nikon high end DC such as CP5700 as it has recovery function. It is because I want to buy Lexar CF, but I use G2, so the boss of DC shop told me about that.
So, I wonder why CP5700 cannot use this CF.

[sam8]

I am send my CP5700 to check because the photos are too dark even the daytime photos, and the 代理 say it is normal because CP5700 is design in this way so anything can be adjust by the computer in future! Strange answer!

Back to this topic now!

I am using PQI 40X CF card and so far the card is fine for my camera but when the 代理 saw my card on the day that I check my camera as mentioned above, they say it is very danger to use PQI and may cause the camera to break down and they will not responsible for it because PQI is not stable. They told me to use scandisk and my response is scandisk is too slow for digital camera and that is why I use 40x PQI. Then they recommended me to use LEXAR for high performance. I just told them it was too expensive for the same performance!
Today I just know LEXAR may not compatable to CP5700 (regarding to the above command), so good luck to the one who has listen to the 代理 and bought the LEXAR card.

[KWLBrian]

http://www.lexarmedia.com/support/troubleshooting.html#nikon

[KWLBrian]

ref: Europe -Nikon Customer Service:

Nikon constantly checks products from CompactFlash card manufacturers to ensure compatibility with COOLPIX cameras. In recent testing, it's been noted that a small percentage of Lexar Media™ CompactFlash cards did not work properly with the COOLPIX 775 digital camera, even though the cards are listed as approved in the manual. In these rare cases, the camera reports that the CF card cannot be used when inserted in the camera and formatting the card and the recording and playing back of images may not be possible.
Please note the CompactFlash card that is included with the COOLPIX 775 camera is 100% compatible.
To determine if a Lexar card is affected, insert the card into a Nikon COOLPIX camera. If the message "THIS CARD CANNOT BE USED" appears on the colour LCD, Lexar Media™ should be contacted to arrange for a replacement card.

If a Lexar card has been purchased that does not work in the COOLPIX 775 camera, contact Lexar Media™ who will replace these cards at no charge.

European Contact Point
E-mail: eurosupport@lexarmedia.com

[verykinkin]

"I am send my CP5700 to check because the photos are too dark even the daytime photos, and the 代理 say it is normal because CP5700 is design in this way so anything can be adjust by the computer in future! Strange answer!"

Sam Hing,
Everybody use DC will also learn PS, even u use DSLR, u need PS to tune the photo. Do u know DC have a disadvantages that if the photo is overexposure, the over exposure part will become "white" and it is un-tuneable in PS. On the other hand, if the pic is under exposure, u can use PS to tune up the level to make the picture look correct. This is because the limited dynamic range of the CCD.
If you don't want to use PS, u can adjust the EV to get the same result.
So Nikon answer is not strange.

[vkwtsui]

若有些少偏暗是可以接受，但若是too dark，要每幅相tune過先可以接受，那就大麻煩了。

[sevensister]

我雖然討厭 PQI
但無論 PQI 的新卡舊卡用在我的 CP995 身上一直也操作正常

under 少許還可保留細節
over 卻比較難補救
這麼做是有原因的

[sam8]

Thank you verykinkin, vkwstui and sevensister.

I agree with what you say and I am using PS or Nikon Viewer to do the touch up for the photos. However, the problem has been mentioned by vkwstui that I need to touch up every photo before I am happy with the result which cause me a lot of trouble.

I bring it to Nikon because I hope they can adjust the 5700 to have "right exposure" --- not too dark and of course not too bright too.

Since 5700 is the top of the line of Nikon digital camera (not included DSLR), I expected it can provide right exposure in the first place and that is why I think the answer is strange.

Thanks,
Sam.

[tabasco]

Hi everybody,
I'm also using CP5700 and Lexar 40X cf for more than 5 months, they seems both work fine!

[verykinkin]

hi sam,
if every photo ps, i agree , quite time consuming, although u only need to tune the level will be ok. All the detail, color will come out. So set the dc to +0.7ev , the exposure will be optimal, if 光差 is too great, some part over, some part ok. set +0.3 or no ev to allow u have some space of ps processing.
I have tried to photo finish some my photo is 12R, very great, no one expect a DC have such photo finish quality, but it does. Let 's try ar.

verykinkin