[benho]

急、急、急！.....有事請教！
正因為EX-Z750的預設閃光輸出太弱，所以把
閃光强度調到+2，但關上機之後再開，閃光强度
重設成零。但奇怪的是其他的如銳度、飽和度、
對比度又可以SAVE.只有閃光强度?能SAVE.
是我的機有問題還是各位用家的也是一樣？
請回答...Thank You！
是這機的Bug就可麻煩了。每次開機都要重SET –次
到+2,大家注意、注意！

[p999]

benho,
你試下在 Menu --> REC --> Memory --> Flash Intensity --> ON
就可以紀錄低你所調較的閃光輸出設定。
在 Memory 的 sub-menu 下自以自己設定紀錄什麼內容。
你認為閃燈不夠，有無開輔助燈？可以有效加強閃燈範圍的。

[benho]

O.K....Thank You ...P999.
因Memory的中文MENU 內譯作記憶體，而它又內置16M RAm
所以被攪亂了思維。它正確地應叫記憶設定才對。

[EDCH]

Yes, the flash output is insufficient (even you have already adjusted the flash output to +1 or even +2) if the object to DC distance is greater than 6ft. Most of the time it will have a lot of ambient light and affect the white balance of your photo.

However, 750 has a very good feature to adjust (not correct) the write balance. I tried it and it is quite good. It will save an addition photo on your DC and the original one is not affected. So made sure you have sufficient memory on your SD card if you have to do a lot of adjustment.