DCFever.com

Larry Lam · 註冊: 2003-01-24 上載我的肖像

* 用c5050+WCON-08一定要用閃光燈及不能用對焦附助燈(因為遮住了).
* 用Raynox RT5241+52mm UV用閃光燈有黑角.
* 用了CLA-1+43->55 converter用閃光燈有輕微黑角.
* 不用任何adapter正常

相機影室內會粗微粒 ISO-Auto, 快門-1/10, 光圈-F1.8, EV-0

James Jin · 註冊: 2003-01-31 上載我的肖像

So which tube/adapter/filters are you using in the end? I have the Olympus 41->43mm CLA-1 and a B+W 43mm UV filter directly on the CLA-1, so yes there is the dark lower left corner but only if the lens is in full wide. I use the CLA-1 tube with the UV filter mainly to protect the non-changeable camera lens and to avoid the lens crashing into the lens cap if the camera is powered on without taking off the lens cap (believe me, it will happen sooner or later).

James

James Jin · 註冊: 2003-01-31 上載我的肖像

So which tube/adapter/filters are you using in the end? With my C-5050, I have the Olympus 41->43mm CLA-1 and a B+W 43mm UV filter directly on the CLA-1, so yes there is the dark lower left corner but only if the lens is in full wide. I use the CLA-1 tube with the UV filter mainly to protect the non-changeable camera lens and to avoid the lens crashing into the lens cap if the camera is powered on without taking off the lens cap (believe me, it will happen sooner or later).

James

Larry Lam · 註冊: 2003-01-24 上載我的肖像

I use CLA-1+43-55converter+WCON-08

So, you can add a UV on the CLA-1? How?
Because the CLA-1 is same length with the lens.

And where did you find the 43mm UV? DCC?

german24 · 註冊: 2002-12-20 上載我的肖像

我用CLA-1 + 43-52mm ring + 52mm CPL filter or 52mm kenko 2.0 Tele

因找不到 43-55mm ring，2.0 telecon lens 始終有成像圈問題。
只能當是用緊200mm定焦鏡 F-2.4。

BLUE · 註冊: 2002-04-20 上載我的肖像

系呢﹐都幾激氣﹗不過乾脆就吾用內閃

James Jin · 註冊: 2003-01-31 上載我的肖像

I got a B+W 43mm UV filter from a local camera accessory store here in Toronto Canada and it fits the CLA-1 without any problem (I mean there is no lens crashing into the filter problem). And I also got an Olympus 43mm->55mm stepup adapter from the same store.

By the way some of the 43mm filters can not be put directly onto the CLA-1. This all depends on the space you can get between the camera lens and the filter glass since the CLA-1 tube does not offer much space beyond the end of the lens when it is fully out.