Velodyne Impact 10 好新淨,
九龍灣交收,有意請PM電話,
移民朋友交低,唔識夾我部Amp,
用speaker level cal 可正常著機出聲,
約8分鐘後入standby,manual有講點做
應該係簡單setting,
冇時間去搞,當問題機放,
12.6" W x 14.9 D x13.6 H
Cross over 50~200Hz
http://velodyneacoustics.com/pdf/impact/ImpactManual.pdf
Speaker level cal正常著機出靚聲
Manual有教點setup
冇時間去搞standby
Auto Turn on Function :
The subwoofer will turn itself on automatically when an audio signal is present. If no signal is present for approximately eight minutes, the unit will switch to standby mode (Red LED). While in standby mode, your subwoofer will draw very minimal power.
Warning:
If the Sub-Out channel signal level from your receiver is too weak, this feature will not operate properly and shut the subwoofer off while you are listening to it. To correct this, see VOLUME CONTROL section on previous page.